FEATURES:

• Full composite construction, lightweight and strong 
• Two piece wing and two piece stabiliser all for easy transport
• Painted outside the mold so no seam lines
• Pre-installed tubes for servo extension leads
• Optional 3D vector thrust pipe
• Quick Release system on stab and wing
• New Tray Equipment
• 1kg lighter than previous version

Included hardware:

• Complete air frame (including aluminium wing-tubes and fibreglass control horns)
• Pilot-RC electric retracts and electric brakes
• Servo extension leads
• tail pipe design for 80-180N turbines
• 3.3L Fuel Bag
• Pre-prepared pushrods with ball links

*Also available: Turbine Ready version. Includes all the above, plus x8 Pilot-RC servos, all pre-installed and with free wing bags. Just add your own turbine of choice.

Required hardware:

Turbine size:

• 80-160N for normal sport flying
• 170-180N for 3D vector flight – Avoid high speed high G flying

Servos: Total x10 (x5 standard size + x5 medium size)

x3 standard size high torque
x2 for flaps (minimum 40kg)
x1 for rudder (minimum 40kg)

x7 medium size servo (size: 35x15x30mm)
x2 for ailerons (minimum 16kg)
x2 for elevators (minimum 16kg)
x1 for vector elevator (minimum 16kg), this is option
x1 for vector rudder (minimum 16kg), this is option
x1 for steering (minimum 10kg)

Also requires all the usual accessories such as transmitter, receiver, batteries, powerbox and possibly other small accessories.

Aileron: 17mm, Rudder: 25mm, Elevator: 13mm.
Flap: 46mm for take off and 78mm for landing.
The CG is 295mm from the front leading edge on the root of the wing